Plant and Tool Hire for Trade and DIY HAE Logo

News archive


The latest news from the world of Didcot Plant.

Check regularly for the latest announcements of additions to our hire fleet.

Don't forget that you can follow us on Facebook.

Didcot Plant Covid-19 operating conditions.

Changing Excavator Buckets

An excavator bucket resting on the ground prior to being removedThis guide will take you through how to change buckets on the excavators available from the Didcot Plant hire fleet.

Also available to download as a PDF guide.

1. Rest the bucket lightly on level ground (to avoid putting pressure on the bucket pins).

2. Remove the two lynch pins.

3. Push bucket pins out with large screwdriver (do not hit with hammer). If they don’t slide easily reduce pressure from arm. Don’t allow removed bucket pins to collect dirt or grit.

4. Lift boom up, away from bucket.

5. Place new bucket under links.

6. Lower boom to line up holes, making small adjustments as necessary.

7. Slide bucket pin in by hand (it should slide in easily, no hammering) and fit pin. (Note: some buckets have lynch pin locators on opposite side).

!!! IMPORTANT: Injury risk – keep fingers out of holes !!!

8. Lift bucket in the air.

9. Lower rear link (crowd bucket) and line up bucket pin and link by hand.

10. Slide bucket pin in, wiggling bucket if necessary and fit lynch pin.

!!! IMPORTANT: Injury risk – keep fingers out of holes !!!

<< Back to News front page

Didcot Plant Ltd
Basil Hill Road
Oxfordshire OX11 7HJ
Map & directions
tel: 01235 814000
Follow Us

Switch to our mobile site